Difference between revisions of "User:James"

From BuildBrighton
Jump to: navigation, search
Line 11: Line 11:
  
 
Insperation and information for this project comes from the data sheets and [http://www.tuxgraphics.org/electronics/200606/article06061.shtml tuxgraphics.org].
 
Insperation and information for this project comes from the data sheets and [http://www.tuxgraphics.org/electronics/200606/article06061.shtml tuxgraphics.org].
 +
 +
== Sounding Balloon ==
 +
 +
Who doesn't want to launch a telemetry payload to the edges of space (well 30km anyway)?
 +
 +
I know I do. I've started collecting information needed and at the moment, so long as I don't get distracted by something else shiny, I aim to get it going for summer 2010.
 +
 +
* [http://www.natrium42.com/halo/flight2/ HALO Flight 2] somebody else who did this.
 +
* [http://www.digi.com/products/wireless/xtend.jsp XTend RF Modems] modems with the range to get telemetry back during the whole flight.
 +
* [http://weather.uwyo.edu/polar/balloon_traj.html Balloon Trajectory Forecasts] for predicting the flight path.
 +
 +
== UAV ==
 +
 +
Just an idea at the moment but it would be cool if, instead of building a wheeled robot, I built a flying robot. It could take pictures from the sky.
 +
 +
This would use a lot of the same tools and skills as the Sounding Balloon but also a whole lot more.
 +
 +
* [http://diydrones.com/profiles/blog/show?id=705844%3ABlogPost%3A44814 ArduPilot] An Arduino platform based autopilot.
 +
* [http://diydrones.com/ DIY Drones] The place on the Internet to find information about UAVs.

Revision as of 07:29, 27 August 2009

James Grant

James wasn't introduced to a soldering iron until he was in his teens. Since the end of his GCSEs he hasn't really used one much either. But starting in 2008 he found an interest in it again and has since been dabbling in home automation and environmental sensing.

AVR Ethernet board

15082009173.jpg

At the moment he is trying to build an ethernet device controlled by a Atmel AVR using the enc28j60 chip. Not the easiest way to do it but it does give you a breadboard with lots of wires coming out of it looking quite impressive.

Insperation and information for this project comes from the data sheets and tuxgraphics.org.

Sounding Balloon

Who doesn't want to launch a telemetry payload to the edges of space (well 30km anyway)?

I know I do. I've started collecting information needed and at the moment, so long as I don't get distracted by something else shiny, I aim to get it going for summer 2010.

UAV

Just an idea at the moment but it would be cool if, instead of building a wheeled robot, I built a flying robot. It could take pictures from the sky.

This would use a lot of the same tools and skills as the Sounding Balloon but also a whole lot more.

  • ArduPilot An Arduino platform based autopilot.
  • DIY Drones The place on the Internet to find information about UAVs.